News

The working principle of gas-liquid mixing pump
An overview of a gas-liquid mixing pump: gas-liquid mixing pump-also called
        Vortex pumps, ozone-dissolved air pumps, water pumps, gas pumps, gas water pumps, air pumps, aeration pumps, gas-liquid mixing pump. Gas handling equipment, ozone water production equipment, oxygen-rich water preparation equipment, biological treatment equipment. Attention all htm thermostat, refrigerant cycle. Gas-liquid mixing pump inlet
can use negative pressure suction gas, there is no need to use air compressors and air ejector. High-speed rotating impeller mixing of liquids and gases, so no blender and mixer. Due to the pressure in the pump mix gases and liquids to fully dissolve, dissolve efficiency of up to 80~100%. So no big pressure dissolving air container or expensive towers to produce highly soluble liquid. Gas-liquid ratio of about 1:9 (inspiratory capacity as 8-10%), the series can increase the suction. A gas-liquid mixing gas-liquid pump can attract, mixing, dissolving and height solution directly to the point of use. Pump 1-50 M3/H; 1-150 M3/H water. Therefore, the use of gas-liquid mixing pump can improve dissolved gas production efficiency, simplify preparation devices, saving space, significantly reduces initial investment, savings in operating costs and maintenance costs.
II, the working condition of gas-liquid mixing pump:
        thin, clean, low viscosity, fine or liquid liquid
 
pH in the range of 3~9;
 
liquid temperature:-15 ° c to + 120 ℃;
 
maximum ambient temperature: + 40 ℃ ;
 
gas-liquid ratio of about 1:9 (suction 8-10%);
 
suck the height as 9-NPSH (m);
 
level to the suction, vertical outlet.

Prev: The basic principle of metering pump

Next: Submersible sewage pump fundamentals

Back Page

Copyright 2018 polishingcx.com, All rights reserved.